Cadence Archives - Page 3 of 4

How to snap to grid a Cadence Layout

Cadence, Circuit Design24 November, 202421 February, 2021 by Alberto L.

In DRC checks, the WARNING “OFFGRID vertex on layer M1 at location xx,xxx,xxx in cell XXX”.

How to Find Warning Errors in Cadence (or ignore them)

Cadence, Circuit Design24 November, 20249 February, 2021 by Alberto L.

It is a bit annoying working with schematics in Cadence Virtuoso, and you “CHECK&SAVE” to see the window emerging with the same warnings you already know.

How to performe a Monte Carlo Simulation in Cadence Virtuoso

Analog, Cadence, Circuit Design24 November, 202419 February, 2020 by Alberto L.

Monte Carlo analysis is a statistical technique used to analyze the behavior of a circuit under varying conditions of PVT (Process, Voltage and Temperature) caused by manufacturing or environmental variations (temperature, voltage, mismatch, etc)

How to export a Plot from a Cadence Simulation to graph in Matlab

Cadence, Circuit Design24 November, 202410 October, 2019 by Alberto L.

How to plot in Matlab a simulation from Cadence? How to export a Cadence graph to Matlab?

Solar Cell Verilog Model for Cadence

Cadence, Circuit Design, Mixed Signal, Verilog24 November, 202418 June, 2019 by Alberto L.

A model of the solar cell is built in Verilog-ams. This is needed in order to perform the simulation of the MPPT in a Solar Energy Harvester.

How to change the wire colour in Cadence

Cadence, Circuit Design24 November, 20247 May, 2019 by Alberto L.

Change the color of some wires in Cadence Virtuoso can be useful in schematics with a lot of wires.